- “Heat can escape”
- “Allows snow & dirt to come under the door”
I designed this product when my concrete garage floor became uneven allowing snow and dirt to blow into my garage and the heat to escape.I called a garage door company and they told me there was nothing they could do and to call a cement contractor.The cement contractor quoted me $2200.00 and told me the floor would probably lift again within three years. Now what, how do I fix this without spending some crazy amount of money, well, after some trial and error, the Snirt Stopper was born.Montie’s contact information: Montie Beyer 701-809-8133 Business mailing address: High Plains Industries, LLC 1100 – 19th Ave. N, Unit J P.O. Box 156 Fargo, ND 58102 Email address: firstname.lastname@example.org
Snirt Stopper | Device designed to keep mice and weather out of the shop
Posted Oct. 19th, 2012 by Ron Lyseng
FARGO, N.D. — In years when the bins are full, farmers sometimes temporarily store grain in quonsets and machine sheds.
But unless the bottom of the door has a perfect fit with the concrete, it leaves a crack for rodents to get in.
On the Prairies, a door that fits perfectly one month might have a two-inch gap next month because of shifting caused by weather and other factors. There are many types of rubber gaskets that fasten to the bottom of doors, but they don’t compensate enough to make up for the shifting floor.
Fargo inventor Montie Beyer thinks he has found a better way to keep rodents, snow, dirt, cold air and other unwanted elements from sneaking through the cracks.
The Snirt Stopper seals domestic garage door bottom gaps up to two inches.
The mid-size Snirt Stopper seals gaps up to four inches and the six-inch Snirt Stopper seals large industrial doors up to six inches.
It is designed for overhead and sliding doors, and has been installed on semi trailers with roll-up doors.
Snirt Stopper consists of a flexible foam cylinder wrapped in an 18-ounce, double-weighted, rubber-based tarp material. The device is held together by polyurethane thread, which Beyer likens to wire, to prevent rodents from chewing it.
To install, Snirt Stopper’s tarp has two tabs, one of which is screwed to the inside of the door with self-tapping screws. This leaves the foam cylinder to hang below the gap, but not slide under the door.
The other tab is not attached, so it floats in under the bottom edge when the door is closed. This locks the cylinder into place because it’s locked in at spots where the door touches the concrete.
“We do not close the door on the foam,” said Beyer, adding that the foam cylinder always stays inside the door. When the door is closed, the Snirt Stopper is inside the building, resting on the concrete floor.
“The material is the same as we see on trucks. It lasts up to 20 years out in the elements, so it should last a lot longer inside the shop.
“We’ve had our first Snirt Stoppers out for three years, and so far there have been no reports of mice chewing the tarp.”
Beyer said he built the first prototype for his garage door because he was fed up with adjusting it. Every device he found on the market was installed so the door closed on it.
“There was a lot of trial and error and a lot of stuff went in the garbage before I came up with something that works.
“One of the main benefits of a hanging stopper is that it’s flexible enough that it doesn’t freeze to the floor and rip when you open the door.”
The Snirt Stopper for domestic garage doors has a diameter of 1.25 inches and sells for $6.50 per linear foot. The four-inch diameter device has an solid inner foam core wrapped in a softer foam, and sells for $8 per linear foot.
The six-inch diameter device also has two foam layers and sells for $10 per linear foot.
For more information, contact Montie Beyer at 701-238-8567 or visit www.snirtstopper.com.
A Garage Door Seal that actually fixes the gap under your garage door!
What the heck is a Snirt Stopper?
We have designed a garage door bottom seal and threshold seal that mounts to the inside face of the door instead of the bottom, this gives you the ability to adjust the seal up or down allowing you to match any unevenness (up to 2 inches) of shifting floors and garage doors.
Do you have a garage door gap? Does it let in light, cold air, leaves and snow?
The Snirt Stopper the ultimate garage door seal helps with little gaps, medium gaps and large gaps up to 2″. If you have more than a 2″ gap click here.
7 Main Benefits
- Saves energy costs
- Helps to prevent garage doors from freezing to the ground
- Helps to keep unwanted pets and critters out of your garage
- Fits uneven conditions of doors to floors
- Easy to install. Comes with Self Tapping Screws (refer to installation video)
- Insulated foam core helps to insulate the bottom of the door
- Tab is under the door and is always adjusting to floor
Please check out our photos and see what this door seal can do for you. THANKS
NEW Ultimate Side Door Seal
a Real Problem and saves
people Real Money!
Thanks so much for a quick easy inexpensive way of fixing a real problem…”[– Will Clark – CEO, C.I.S. Inc. – Alabama ]
“Hi. I just installed my 16′ snirt stopper and it looks awesome. Hopefully it looks and works as good in the winter as it does now. There is nothing here like it, so the $99 I paid was worth every penny. This would be a perfect product for this area that I live in. Thanks.”[– Brad H. – Saskatoon – Sk. Canada ]
“Dear Snirt Stopper, I have never written a letter like this before however this product (Snirt Stopper) has performed beyond my expectations. I have had a garage door next to an area (my office) that was always cold, I put the Snirt Stopper on that door…”[– Bill Norris – Weivoda Carpet – Dilworth, MN ]
No Paypal account?
READ HOW >>
Allow 7-10 business days for shipping.